nanouf.blogg.se

Pull the hard drive cable away from the body of the hard drive. It is still attached to the hard drive cable.  Don't try to completely remove the hard drive just yet. Use the attached pull tab to lift the hard drive out of the upper case.  The hard drive bracket may be firmly seated against the upper case.  These screws will remain attached to the hard drive bracket. Remove the two Phillips screws securing the hard drive bracket to the upper case. Be careful with the corners of the connectors, they can be easily broken off.īend the battery cable slightly away from its socket on the logic board so it does not accidentally connect itself while you work.

 It is useful to pry upward on both short sides of the connector to "walk" it out of its socket. Use the edge of a spudger to pry the battery connector upwards from its socket on the logic board. Use your fingers to pry the lower case away from the body of the MacBook near the vent. Universal Drive Adapter (1) MacBook Pro 13" Unibody Hard Drive Bracket (1) 120 GB OCZ TL100 SSD (1) 240 GB OCZ TL100 SSD (1) 480 GB OCZ TR150 SSD (1) 960 GB OCZ SSD (1)įour 3.5 mm shouldered Phillips #00 screws INTRODUCTION Use this guide to replace a dead hard drive.ġ TB SSD Hybrid 2.5" Hard Drive (1) Upgrade Kit This kit contains the drive and all tools needed.ĥ00 GB SSD Hybrid 2.5" Hard Drive (1) Upgrade Kit This kit contains the part and all tools needed. MacBook Pro 13" Unibody Late 2011 Hard Drive Replacement Replace the hard drive in your Late 2011 MacBook Pro 13" Unibody. MacBook Pro 13" Unibody Late 2011 Hard Drive Replacement